Author Topic: 'Uprated' G40 charger bits.  (Read 976 times)

Offline Justin14100

  • Traders
  • *****
  • Posts: 792
'Uprated' G40 charger bits.
« on: October 14, 2010, 05:21:20 pm »
been looking around on the german sites for funky G40 parts and noticed they sell 'uprated' things was wondering if they were actually worth anything or not.
BAR-TEK sell the uprated bearings:,showdetail,25206,en,1287072766-25398,g-lader.1132925576,1100007,8,Tshowrub--g-lader.1132925576,.htm
anyone tried these - would they really offer the ability to run smaller pulleys like a 63/60mm on a toothed setup?
another one is these sealing stripes:
i spose the efficiency of the Glader is all dependent on how well these work - saw on ebay some uprated 'motorsport' stripes before too - might be worth a go if they can raise the boost slightly.
I know the beige strips get you a slight bit more boost so wonder what these would result in. did vw motorsport use different stripes?

Offline PeteG40

  • Administrators
  • *****
  • Posts: 4010
  • Housewives heart throb
Re: 'Uprated' G40 charger bits.
« Reply #1 on: October 15, 2010, 10:23:43 am »
the 'motorsport' strips i've seen are cheapo ones and i bet have never seen vw motorsport.

Offline polo classic

  • Members
  • *****
  • Posts: 260
Re: 'Uprated' G40 charger bits.
« Reply #2 on: October 15, 2010, 01:18:43 pm »
I have used the SNR's in a few hardcore g-laders, eg loads of porting and small pulleys