Kent Cams Vernier Pulley

Karlos the jackyl · September 01, 2009, 08:43:42 PM

For sale is a Kent Cams Vernier pulley

I had this custom made by kent cams , and used this to fine tune my car to get the best spread of power.

I dont think Kent cams make these off the shelf and It cost me roughly £130. This worked wonders on my car and gained me roughly 7-10 hp top end by swinging the wheel.

This is an authentic lightweight Alloy type pulley and not a machined down mild steel standard pulley

Unfortunately the thread on 1 nut is rounded ,3 torque up tight. I used this fine like this since I owned my G40. but if you're a prefectionist you could dab some weld on the back and or tap the thread.

£50+ £5 P&P

Paypal accepted

Robin · September 01, 2009, 10:32:51 PM

i'll have it

you got pm.

lance · September 01, 2009, 10:41:11 PM

didnt think it would be up for sale long!

hayesey · September 02, 2009, 09:17:11 AM

oh rocket you tw@t! why didn't I see this last night

Karlos the jackyl · September 02, 2009, 10:08:33 AM

SOLD

Robin · September 02, 2009, 10:26:02 AM

UBER LOL @ hayes!

cheddarcheese · September 02, 2009, 11:31:37 AM

hayesey · September 02, 2009, 12:28:12 PM

hmm, where's the ban button?

robin has even sent me an email with the same "uber lol" message in from his work email!

Nick_S · September 02, 2009, 02:41:12 PM

You can always get a LOL back when on the rollers Paul.

hayesey · September 02, 2009, 03:48:59 PM

not if I don't get a vernier to sort out my cam timing first

I'll guess I'll just have to put my hand in my pocket.

I'll get a LOL at the weekend when I see rocket and kill him.

lance · September 02, 2009, 04:05:42 PM

phil has some sort of one for sale.

hayesey · September 02, 2009, 05:06:41 PM

it's a square tooth one though as far as I'm aware, so no good as mine (as most g40s do) have the round tooth profile.

Robin · September 02, 2009, 07:11:08 PM

LOL again

Karlos the jackyl · September 02, 2009, 07:17:33 PM

I'll be in the cave again tonight looking for stuff to flog , still lots to go through!

Yoof · September 02, 2009, 10:33:27 PM

Hayesey- Liam found 6 of our original ones, he should be at edition, will sort you one out.

Plus it looks better than Robin's.

"You can always get a LOL back when on the rollers Paul. "

Hardly anything between the two cars to be honest Nick, would say it all depends on the final map, but being as Andy's doing them both it's down to BVH 1272cc and 1341cc stock head... should be interesting!