Kent Cams Vernier Pulley

[Karlos the jackyl]

For sale is a Kent Cams Vernier pulley

I had this custom made by kent cams  , and used this to fine tune my car to get the best spread of power.

I dont think  Kent cams make these off the shelf and  It cost me roughly £130. This worked wonders on my car and gained me roughly 7-10 hp top end by swinging the wheel.

This is an authentic lightweight Alloy type pulley and not a machined down mild steel standard pulley

Unfortunately the thread on 1 nut is rounded  ,3 torque up tight. I used this fine like this since I owned my G40. but if you're  a prefectionist you could dab some weld on the back and or tap the thread.


£50+ £5 P&P

Paypal accepted

[Robin]

i'll have it

you got pm.

[lance]

didnt think it would be up for sale long!

[hayesey]

oh rocket you tw@t!  why didn't I see this last night 

[Karlos the jackyl]

SOLD

[Robin]

UBER LOL @ hayes!

[cheddarcheese]

 

[hayesey]

hmm, where's the ban button?

robin has even sent me an email with the same "uber lol" message in from his work email!

[Nick_S]

You can always get a LOL back when on the rollers Paul.

[hayesey]

not if I don't get a vernier to sort out my cam timing first  I'll guess I'll just have to put my hand in my pocket.

I'll get a LOL at the weekend when I see rocket and kill him.

[lance]

phil has some sort of one for sale.

[hayesey]

it's a square tooth one though as far as I'm aware, so no good as mine (as most g40s do) have the round tooth profile.

[Robin]

LOL again

[Karlos the jackyl]

I'll be in the cave again tonight looking for stuff to flog , still lots to go through!

[Yoof]

Hayesey- Liam found 6 of our original ones, he should be at edition, will sort you one out.

Plus it looks better than Robin's.

"You can always get a LOL back when on the rollers Paul. "

Hardly anything between the two cars to be honest Nick, would say it all depends on the final map, but being as Andy's doing them both it's down to BVH 1272cc and 1341cc stock head... should be interesting!