Author Topic: Uprated Driveshaft Single orders accepted 2013  (Read 27978 times)

Offline Karlos the jackyl

  • Members
  • *****
  • Posts: 379
    • VW Polo
Re: Uprated Driveshaft Single orders accepted 2013
« Reply #90 on: December 29, 2018, 11:32:10 am »
I'll investigate this again in the new year

Offline dazzle53

  • Members
  • *****
  • Posts: 163
Re: Uprated Driveshaft Single orders accepted 2013
« Reply #91 on: December 30, 2018, 10:09:18 am »
Brilliant. Looking forward to an update.

Offline vwmk3jon

  • Members
  • *****
  • Posts: 1422
Re: Uprated Driveshaft Single orders accepted 2013
« Reply #92 on: January 03, 2019, 09:02:12 pm »
Me too.

Offline Karlos the jackyl

  • Members
  • *****
  • Posts: 379
    • VW Polo
Re: Uprated Driveshaft Single orders accepted 2013
« Reply #93 on: January 04, 2019, 11:03:58 am »
Does anyone have a stock driveshaft spare that I can loan / borrow to use for the tooling... I thought I had a spare but I think it got binned. Im in Hertfordshire if anyone is local.

Thanks

Offline dazzle53

  • Members
  • *****
  • Posts: 163
Re: Uprated Driveshaft Single orders accepted 2013
« Reply #94 on: January 04, 2019, 01:37:19 pm »
Not sure if I do but I will have a check and see and get back to you.

Offline Karlos the jackyl

  • Members
  • *****
  • Posts: 379
    • VW Polo
Re: Uprated Driveshaft Single orders accepted 2013
« Reply #95 on: January 09, 2019, 09:19:15 am »
Not sure if I do but I will have a check and see and get back to you.

Thanks , I've sorted one now

Offline RyanC

  • Members
  • *****
  • Posts: 366
Re: Uprated Driveshaft Single orders accepted 2013
« Reply #96 on: January 27, 2019, 11:01:28 am »
A little feed back on the shafts. Work prefect for me but I did add a stop to each end so you could use the concave washers to stop the joint moving on the shaft. Mine had a lot of movement before and actually produced a noise due to the inner cerclip knocking against the joint over bumps where it was able to float on the spline. But nothing a few hours couldn’t fix though  🙂