I remember reading about how you could set up a potentiometer to adjust from the driver's seat. Can't find where I read it or if it was some thread on here.
I ordered the parts, 2k potentiometer dial, a 3.5 digit ohm displlay and a step down piece 12v to 5v for the 3.5 digit display.
The plan was to set it up, bypassing the CO pot to be able to adjust it using the display (dial has values on it, but the display looks nicer).
But I know the CO pot has a temp sensor also....
My question is this, to wire the potentiometer, I would have to tap into the 1 & 3 terminals, is this correct?
2 is for the IAT?, only one wire required?
The need to adjust Co is due to mods and tune