down on power

Started by g40josh, January 31, 2015, 03:14:26 PM

Previous topic - Next topic

g40josh

hi had lots of head work done on the car, put a four branch on it replaced all seals and gaskets in the head kit. I had the inlet manifold off and super charger. built back up runs fine on Idle but took out on road test and not boosting as much and really slow any ideas ? Cheers

Jezza-7

Sounds like it could be a split boost pipe or loose pipe, vac pipe has come off?


g40josh

It hold boost and stuff I will try have a play with them and it seems fine when I rev it up on the top of the throttle body just when you rev it in the car

GR40

Check the black sensor on the plastic boost pipe. If it's abstracted or disconnected power goes out the window! Had a similar problem when the metallic ring at the end of the pipe had slipped inside it and got wedged before the sensor. It would boost but make no power!

g40josh

The air flow you mean mate I will check that now and keep you posted thanks

Jezza-7

Its a CO-POT, not an air flow sensor. G40's dont have air flow sensors.

g40josh

Sorry my bad and i think you could be right with that there's a hissing coming from there on boost how did you get it to seal mate ? Cheers aswell

randombadger69

Spray some soapy water in the direction of hissing. There is a rubber o-ring under the co pot which creates a seal in conjunction with the u-clip. It's the same size o-ring as the blue and black water temp sensors use in the thermostat housing.

Worth inspecting for damage/fit.