1303cc PY block with wossner forged pistons to suit.

[ctothey]

Hi, for sale as for above..
Genuine PY block over bored too 1303cc..
Engine covered approx 5k, car was then rear ended..
Hence reason for sale..
Con-rods missing as sold too a friend (were forged)
Ideal for someone who's joined the melting piston club, so you can use your own bottom end components in this block with forged pistons..
Pistons in almost as new condition,
Cylinder bores have next to no wear and honing marks still visible.
Pics available upon request..
These Pistons usually retail 500-600..

550 ovno.

For more info : Matt 07590767606.
(Twickenham area)
Can deliver at a  cost if not a million miles away.
No time wasters or idiots please.

[randombadger69]

Are these 76mm pistons? Making 1306.5cc?

[ctothey]

Hi fella..
The part no on the wossner box is 9096D200
When I spoke to them too find out cc they said 1303.
Maybe they were wrong..
Also says 76,93mm on box..
I just gave all four pistons and the block to an engineering shop and said
"Make these fit". Lol
Hope this helps.

[sleag40]

1341 chief.

[Etches]

This is cheap for someone wanting the 1341 conversion!

[Kustom]

I think this is spot on the money the pistons can be bought from phil for £460 then its another £100ish to get a block bored to take the pistons.

[ctothey]

Cheers guys.. i'm not so sure that its 1341 myself..
suppose the only way too find out is fit them on a crank and measure the cylinders cc.
sadly i dont have the time for that..
anyone thats interested, gimme a txt as my phnoe sometimes misses calls, and ill give u a call back.
thanks.
cy

[Etches]

Cheers guys.. i'm not so sure that its 1341 myself..
suppose the only way too find out is fit them on a crank and measure the cylinders cc.
sadly i dont have the time for that..
anyone thats interested, gimme a txt as my phnoe sometimes misses calls, and ill give u a call back.
thanks.
cy

Don't worry mate, the size of the pistons dictates that its a 1341 anyway!

[ctothey]

Cool.. Thanks for clearing that up.. I'll give the piston crown a measure at some point and report back.

[Robin]

I reckon Hayes should buy this!!

[Etches]

I reckon Hayes should buy this!!

I remember Paul chucking up a wanted thread a while back!

[hayesey]

I was after Accralites with higher CR though.  I have given up on that now since 2nd hand ones seem non-existent and new ones are eye wateringly expensive.  I will get some wossners but I want to be certain I am getting 1341 ones and I think I'll just buy pistons.  I like building my own engines too

[Etches]

When I was buying the accralites worked out at a couple of hundred quid more, hence the wossner choice

[hayesey]

it's looking to be around £300-£350 difference at the minute

[samuel.cole]

anyone suggest a decent conrod set which would match, would standard cup g40 conrods be up to the task?