Belt Length for Bar-Tek Toothies? Ans = 1000 8M

[G40 AD]

Hi is anyone aware of the correct belt length for Bar-Tek Toothies with a 65mm charger pulley? Cant make it out from their website and €40+ for a belt is ridiculous can get them in the uk much cheaper just not sure of the length required!!

Cheers

Ad

[scotsjohn]

PSD kits used 8mm pitch and operate on anything between 1000 and 1040mm belt length. If Bar-Tek use the same pitch then anything between those sizes will be OK ie 1008, 1016,1024,1032. If you've got a stock charger to intercooler pipe then it'll probably be nearer 1000 than 1040 which needs a longer pipe. Just as important as length is tooth profile. If you don't have an old belt, take a pulley to your nearest bearing /belt suppliers to get a correct match. £20 is more like the price.

[G40 AD]

Cheers Jon... yeah its a 1000m 8 that I need... think my PSD mani is phase 1 so guessing the 1000 should be fine but we'l see...

Anyone used Bearing Boys before sounds a touch homosexual but the prices are right!!
http://www.bearingboys.co.uk/basket.cgi?id=6248&shipping=16&action=update&qty=2

Cheers

Ad

[Justin14100]

I think I got a bearing boys one that was square tooth once, if they are round toothed I get these ones:
http://www.amazon.co.uk/Medway-1000-8M-20-Timing-Belt/dp/B002T8V2CG/ref=sr_1_1?ie=UTF8&qid=1331762773&sr=8-1

[G40 AD]

Forgot to check tooth type! Oh well should be here tomo so we'll see what happens when the belt arrives tomo!!