Print Page - Bumper cut outs??

Title: Bumper cut outs??
Post by: Dan:) on December 09, 2011, 10:49:31 PM

Whats the best method for cutting out the fog light holes??
I was thinking drill out holes then use a hack saw, then file down. Would this be a good method??

Title: Re: Bumper cut outs??
Post by: cheys03 on December 10, 2011, 12:53:54 AM

I used a Stanley knife

Title: Re: Bumper cut outs??
Post by: genesisGT on February 23, 2012, 01:45:16 PM

jigsaw with a plastic cutting blade and a wee cardboard template

Title: Re: Bumper cut outs??
Post by: hayesey on February 23, 2012, 01:53:07 PM

one of those mini circular saw things on a dremel does a pretty good job of it too.

Title: Re: Bumper cut outs??
Post by: vwmk3jon on February 23, 2012, 06:11:23 PM

Quote from: cheys03 on December 10, 2011, 12:53:54 AM
I used a Stanley knife

mustve either been a bloody good knife or a kaput bumper?

Title: Re: Bumper cut outs??
Post by: PeteG40 on February 23, 2012, 07:55:56 PM

stanley knife is ok. Dont go right to the outer of the hole... the OEM foglight bumpers have a ridge inside this.

Title: Re: Bumper cut outs??
Post by: hayesey on February 24, 2012, 09:41:22 AM

I've cut the bumper with a stanley knife, you need a brand new really sharp blade. And you have to use a fair bit of force and be careful not to slip! I reckon using a dremel gives you more control

Club G40 Forum

Technical => Exterior and Interior => Topic started by: Dan:) on December 09, 2011, 10:49:31 PM