Club G40 Forum
Technical => Exterior and Interior => Topic started by: Dan:) on December 09, 2011, 10:49:31 pm
-
Whats the best method for cutting out the fog light holes??
I was thinking drill out holes then use a hack saw, then file down. Would this be a good method??
-
I used a Stanley knife
-
jigsaw with a plastic cutting blade and a wee cardboard template
-
one of those mini circular saw things on a dremel does a pretty good job of it too.
-
I used a Stanley knife
mustve either been a bloody good knife or a kaput bumper?
-
stanley knife is ok. Dont go right to the outer of the hole... the OEM foglight bumpers have a ridge inside this.
-
I've cut the bumper with a stanley knife, you need a brand new really sharp blade. And you have to use a fair bit of force and be careful not to slip! I reckon using a dremel gives you more control