All flogged

[physicsfool]

All flogged

[Bushpig]

Evening ,

With the chip does it come attached to the ecu or is it separate?

Does the cam come with a aftermarket pulley or did you just bolt the standard one on?

Did you ever have the whole lot running together the cam and chip ?

Guessing you ran a ported charger and smaller pulley as well  that the chip recommends?

Cheers Danny.

[physicsfool]

Hi Danny,

The chip comes separate, so all you need to do is open the ECU and push this chip in.
I just ran the cam with the standard pulley and it was fine.
I got 110Bhp at the wheels with this cam chip ported supercharger and 65mm v belt pulley. It ran very nicely and I used the car daily.

Cheers
Martin

[Bushpig]

Is that all it is a case of pushing it into the motherboard not soldering? With all those mods is that all it achieved??

Cheers Danny

[physicsfool]

Yes the chip just pushes in, there is a guide somewhere on here or club polo. Its not hard just make sure you put the chip in the right way.

Yes every G is different and having broken my engine to rebuild i can see there was a bit of blowback around the pistons so an engine in better condition would achieve more. but that equates to roughly 130bhp at the fly.

[Bushpig]

Is it possible to get a few pics of the condition of the cam?

Cheers Danny.

[Bushpig]

Did you need to change the buckets to suit the cam or any modifications to head ?

Cheers Danny.

[physicsfool]

I didnt need to and i checked my head and it hasnt been modified. I bought new INA tappets off PeteG40 (check his section below) but as they havent done many miles i am keeping them for my other cam.

[Bushpig]

Are you available tonight for me to bob over to Malton?

[physicsfool]

Yeah sure, anytime before 8pm. will pm you my number and address

[physicsfool]

Cam and chip sold