oil seals and springs fail

[G_CoNeCtioN]

Hi i have a problem with this charger always its a oil seal or a spring who pops out.
I already change 3 main shafts so whats rong?the oil seals are the good ones viton high pressure.
Can you guys help me?

[PeteG40]

Check yr oil pressure.  Breather blocked,  drain blocked etc

[G_CoNeCtioN]

Its all alright maybe its the bearing from scroll?

[PeteG40]

if the oil seal pops out - do you bond them in?

[G_CoNeCtioN]

Yes

[PeteG40]

In extreme cases the scroll centre can wear so seals pop.  So.it needs sleaving.


However its normally excess oil pressure that causes them to pop
.
Either blocked shaft or oil drain on the block or in the charger pulley side or a blocked breather or kinked breathee hose

[paulg40]

When I took one of my chargers apart I found lots of metal stuck in the main shaft oil way, it was the left overs of an old Oil Seal spring, it had broken up and I reckon once all was out (it took me ages to fish it all out!) I had enough to build the pressure up on one side of the charger seals.

this was a charger I bought second hand so I never ran it like this but I dare say it couldn't have been efficient running like this.

So if you have the charger apart check the oil ways inside the main shaft!