Club G40 Forum
Technical => Superchargers / G-Lader => Topic started by: xrrich on April 27, 2010, 06:27:37 pm
-
Hi im fitting a 65 MM pulley.
is there a brief guide of how to do it and what tools are needed.
Is it best to get a new belt?
Thanks
Rich
-
Isit a toothed pully or a 65mm twinV, if its the twin V just loosen of the charger, unhook the belts and remove the pully with a chainwhip, sorta like a pushbike chain, it holds the pully whist you undo the bolt holding the thing on, only change the belts if they need changeing, no point in throwing money away! o and when you put the bolt back in locktite it in, last thing you want is it coming loose!
-
Its a 65mm twinV. The chain whip like the ones used to get oil filers off that are crap? ha
Yeah cheers for the advice,
How would it run without a chip to suit?
Cheers
Rich
-
Wrap an old bit of V belt round the pulley before using the oil filter chain wrench thing to avoid damaging the pulley.
-
Can you run without chip?
How does it differ?
-
yes you can run it without a chip, it'll make less power though.
-
You can also use a G-clamp on the pulley which is a good method.
-
Brilliant, i will have a go over the weeekend