Club G40 Forum

Technical => Superchargers / G-Lader => Topic started by: Robin on May 19, 2009, 09:42:41 pm

Title: Quick Lader Bearing Question
Post by: Robin on May 19, 2009, 09:42:41 pm

I have rebuilt my lader with a new seal as it popped one last week.

Just noticed that the bearing which sits next to the small toothed belt is not sitting flush with the seal, is this correct?

Title: Re: Quick Lader Bearing Question
Post by: tdh-syorks on May 20, 2009, 06:49:24 pm

Hi Robin

don't think mine did either, sat slightly proud. been on car and runs ok, not took it out yet and tested it properly.

cheers Tom