Club G40 Forum
Technical => Superchargers / G-Lader => Topic started by: Alexiskayak_7 on January 06, 2009, 10:34:35 am
-
Well...I have a totally stock g... When i placed a boost gauge i had 0.4@3500-4500 and 0.65@6000rpm...
After i sprayed ptfe at the charger (i spayed more than i have to) it was showing 0.5-0.55@6000rpm...
I have NO boost leak ( i triple checked al my boost hoses...
How can i solve the probem?
-
is you boost gauge a good quality one
and check that the hose you tapped vacume from isnt leaking and the hose to your gauge isnt leaking
-
Are these readings taken on the road or standing still ? Try a reading at over 5000rpm in third gear; you should see about 0.7bar from a stock charger in good nick.
-
Are these readings taken on the road or standing still ? Try a reading at over 5000rpm in third gear; you should see about 0.7bar from a stock charger in good nick.
These readings are taken while i was on road...
My problem is that my boost was ok before spraying ptfe... After i sprayed ptfe i had less boost presure...
I sprayed 2-3 bursts more than i had to...
Also the hose that is from the down side before CO pontetiometer is on position and it's not cutted...
-
what ptfe grease are you using?
-
Wurth's PTFE spray grease...
-
wouldn't have thought it would drop
sorry cant help more
-
a worn or torn apex seal maybe????? ??? ???