Club G40 Forum

Classifieds => Parts for sale => Topic started by: grungeisdead on April 03, 2013, 02:24:09 AM

Title: Garret T25 Turbo/Manifold/Downpipe for small block 8v's, 500 quid
Post by: grungeisdead on April 03, 2013, 02:24:09 AM
Garret T25 Hybrid Turbocharger

- Fitted with a new dynamic oil seal as it was pushing oil past the seals when I first got it running.
- Replaced the old actuator with a new standard actuator
- Comes with a full rebuild kit bar the dynamic oil seal - the kit was around 80 quid

Custom Turbo Manifold & 2 1/2 inch Downpipe - downpipe is stainless with an extra lambda bung for fitting a wideband

G40 Turbo T25 ECU Map
- It's of unknown origin but will get you running - ideally you want a custom map for long term stability - PPP are the boys to see for this

The above for £500 quid collected

Due to the weight of the turbo/mani and the awkward size and shape of the downpipe, id send as two seperate packages. probably around 30 quid to send both but would have to check.

some pics of when i stripped it down - will get pics tomorrow now that its all off the engine (the manifold and downpipe were modified - cut and welded - after this pic so the turbo was moved inwards towards the engine, moving it further away from the rad, and the downpipe was made to clear a stage 3 subframe, and the sump. it was unprofessionally modified by the driveshaft headshield with a sledgehammer - brute yes, but it did the job well and cleared enough it not to melt a single CV boot - result!.)

exhaust housing removed and orientation marked in true PTNT fashion

(http://i16.photobucket.com/albums/b12/yousafn/DSC_0965.jpg)
(http://i16.photobucket.com/albums/b12/yousafn/DSC_0967.jpg)

lots of burnt oil and oily residue behind the heat shield

(http://i16.photobucket.com/albums/b12/yousafn/DSC_0968.jpg)

the compressor side

(http://i16.photobucket.com/albums/b12/yousafn/DSC_0970.jpg)

shaft after removing old oil seal but before cleaning out the grooves

(http://i16.photobucket.com/albums/b12/yousafn/DSC_0971.jpg)

new stepped oil seal fitted

(http://i16.photobucket.com/albums/b12/yousafn/DSC_0975.jpg)

back on the car

(http://i16.photobucket.com/albums/b12/yousafn/DSC_0991.jpg)


VIdeo of the first run up to temp

(http://i16.photobucket.com/albums/b12/yousafn/th_MOV_0989.jpg) (http://"http://s16.photobucket.com/albums/b12/yousafn/?action=view&current=MOV_0989.mp4")