Club G40 Forum

Technical => Engine and Transmission => Topic started by: matthg40 on September 09, 2011, 08:25:16 PM

Title: Please help running problem still
Post by: matthg40 on September 09, 2011, 08:25:16 PM
Rite here goes when my 40 drops below 1000 revs it stalls I ve checked all earths and now I'm stuck I can do anything with my eyes closed on my polo but soon as it comes to electrics I'm stuck if anyone has pointers for me please suggest many thanks matt
Title: Re: Please help running problem still
Post by: AlexG40 on September 09, 2011, 08:51:33 PM
Checked for vacuum leaks?
Title: Re: Please help running problem still
Post by: matthg40 on September 09, 2011, 08:57:28 PM
Yes mate I've swapped everything over from my old polo to a  rolling shell do the engine came out in one piece so I'm still stuck lol
Title: Re: Please help running problem still
Post by: matthg40 on September 09, 2011, 09:07:58 PM
I've. Checked vacuum leak throttle body all perfect pal
Title: Re: Please help running problem still
Post by: matthg40 on September 10, 2011, 09:08:08 PM
I've just took my g out and notices that the headlights are flickering like mad is this linked
Title: Re: Please help running problem still
Post by: AlexG40 on September 10, 2011, 09:14:41 PM
Could be, the voltage to the ECU is critical...
Title: Re: Please help running problem still
Post by: matthg40 on September 10, 2011, 09:25:51 PM
Ah well I'm baffled then matey I dontnno what else to try
Title: Re: Please help running problem still
Post by: cheys03 on September 10, 2011, 09:32:48 PM
It could be 1 of 1000 things.
In honesty, as you admit you're not experienced with electricals and electronics then I'd be tempted to take it to a well-know and recommended car diagnostician.
Title: Re: Please help running problem still
Post by: matthg40 on September 10, 2011, 09:46:25 PM
Yer I was thinking that mate one last thing where is my isv as I have never cleaned it and touched it that could be part of the problem
Title: Re: Please help running problem still
Post by: cheys03 on September 10, 2011, 10:02:10 PM
ISV is below the inlet manifold, bolted to the top of the water pipe that runs along the back of the block
Title: Re: Please help running problem still
Post by: matthg40 on September 10, 2011, 11:19:24 PM
Awesome thank you for your help mate
Title: Re: Please help running problem still
Post by: Peterpolo on September 11, 2011, 08:07:10 PM
Also check your alternator charge rate and battery with a vm, the car will run crap if it's undercharging and that would proberly explain your lights flickering too!
Title: Re: Please help running problem still
Post by: matthg40 on September 11, 2011, 09:48:44 PM
Any idea what the charge rate should be pal
Title: Re: Please help running problem still
Post by: hayesey on September 12, 2011, 09:26:40 AM
should get a good 13v or more across the battery terminals with engine running and everything electrical switched on, headlights, heater fan, rear window demister etc...
Title: Re: Please help running problem still
Post by: matthg40 on September 12, 2011, 11:01:57 AM
Thank you for that mate will get the multimeter out later
Title: Re: Please help running problem still
Post by: matthg40 on September 13, 2011, 12:11:02 AM
Ah I've also noticed it's fine when it's cold but soon as the engine starts to warm up it starts stalling
Title: Re: Please help running problem still
Post by: GR40 on September 13, 2011, 09:47:40 AM
Check if all your grounds are connected. You might forgot one. I know I had similar problems when one of mine had broken I think it was the one that goes from the charger to ground (If one exists. I can't remember. I use one with my eaton now). Also if it stalls when dropping under 1000 check your airflow sensor for dirt and the isv.
Title: Re: Please help running problem still
Post by: matthg40 on September 13, 2011, 11:22:46 AM
Nice one mate will recheck earths and have a look at isv