Morning folks, I went for a spirited drive last night, and after a few bowts of hard accelaration, rather scariliy my accelerator pedal disappeared. I pulled over and popped the bonnet, and the accelerator cable had popped out of the bracket that bolts to the inlet manifold. When I first did the conversion, I checked it had the correct Bracket on for the G40, and the part numbers matched. The only thing I can think is that being a GT cable, its somehow incorrect. But on futher inspection now, it seems to me that the bracket looks close to the bulkhead, so even with a different cable in, naturally it would be trying to pull up.
I just wondered if anybody had, had anything similar happen. I'm going to ring VW in the morning see if there are 2 different cables available, as my ETKA is playing up at the minute, so can't check for mmyself.
Cheers folks
Rich
Have you got GT inlet manifold?
Yup, its a GT inlet, but with a G40 bracket on!
That doesn't matter.
I had the same problem mate. All i did to solve it was put a load of washers under the bracket and used a longer bolt. The GT inlet sits a little lower than the g40 one.
Its well annoying when it happens though!
Quote from: Jezza-7 on March 20, 2011, 12:09:11 PM
That doesn't matter.
I had the same problem mate. All i did to solve it was put a load of washers under the bracket and used a longer bolt. The GT inlet sits a little lower than the g40 one.
Its well annoying when it happens though!
Lol i did that. ****Note to new members**** We're all bodging b*****d's
Cheers for the replies both, nice to know its not me being a wally! I'll roll her back out in the week, and have a looksy.
Cheers both
Rich