Print Page - Which Wire Is This

Title: Which Wire Is This
Post by: SteG40 on December 06, 2010, 01:26:58 PM

I've just finished putting the engine back in but I have this plug spare and I can't work out where it goes and i'm wondering if it has anything to do with it not starting. It goes through the bulkhead with the main loom to the ecu. It has fuel and spark turns over ok but won't fire.

(http://i37.photobucket.com/albums/e63/Mk2Valver/119.jpg)
(http://i37.photobucket.com/albums/e63/Mk2Valver/118.jpg)

Cheers

Title: Re: Which Wire Is This
Post by: scotsjohn on December 06, 2010, 03:06:09 PM

Wouldn't be the lambda?

Title: Re: Which Wire Is This
Post by: Jezza-7 on December 06, 2010, 03:07:47 PM

Lambdas got 3 pin and earth point wire?

Title: Re: Which Wire Is This
Post by: lance on December 06, 2010, 03:10:24 PM

yea lambda is 4 pin that could be co pot?
think isv and knock sensor are on a seperate loom part.

Title: Re: Which Wire Is This
Post by: Jezza-7 on December 06, 2010, 03:15:30 PM

ISV sounds good to me.

Title: Re: Which Wire Is This
Post by: samg40 on December 06, 2010, 04:01:22 PM

My moneys on the knock sensor.

Title: Re: Which Wire Is This
Post by: cheys03 on December 06, 2010, 04:31:55 PM

I would also say definately knock sensor - the cable is the same shielded type as on the sensor itself and it's the only sensor that uses shielded cable.

Title: Re: Which Wire Is This
Post by: woody02 on December 06, 2010, 06:18:38 PM

Il go with knock sensor.

Title: Re: Which Wire Is This
Post by: cheddarcheese on December 16, 2010, 05:41:10 AM

dito looks like knock senser

Title: Re: Which Wire Is This
Post by: SteG40 on December 18, 2010, 06:58:47 PM

cheers folks it was the knock sensor.

Club G40 Forum

Technical => Electrical => Topic started by: SteG40 on December 06, 2010, 01:26:58 PM