Club G40 Forum

Technical => Engine and Transmission => Topic started by: dub-disaster on December 19, 2010, 03:20:37 pm

Title: flywheel,crankshaft pulley, clutch cover torque settings
Post by: dub-disaster on December 19, 2010, 03:20:37 pm

as title says whats the flywheel bolt,cranck shaft pulley and, clutch cover toprque settings that i should be using haynes give different values to autodata which one is the one that i should be using ?? for example haynes says crankshaft pulley is 80nm where as autodata says 90nm plus 120 degrees for a hex bolt , thanks

Title: Re: flywheel,crankshaft pulley, clutch cover torque settings
Post by: hayesey on December 19, 2010, 04:30:40 pm

I've just always used haynes since I dont have autodata.

Title: Re: flywheel,crankshaft pulley, clutch cover torque settings
Post by: dub-disaster on December 19, 2010, 04:50:36 pm

ill stick with haynes then, i was only looking at the auto data on a post on here as i left my haynes at work. just 120 degrees and 10nm more seemed like a big difference to me !