Started on making things lighter, these are a pair of doors i got off Tez a couple of weeks ago, outside handle is now off an Audi A4.
The scruffy after thought of a window winder is only on the drivers side. I dont have a heater in the car so need to wind the window down to stop condensation. The back of the winder metal has some fibreglass angle iron and the front has a ''doorcard'' cover, as seen below:
This is a ''during'' pic of the wing:
Wings have no side reps, trimmed metal along the front where it bolts to the wing mount bit and the top edge has had the spreader plate moved and the metal under trimmed back between the bolts.
Finally a pic of a piece im working on, 25" across, sure you can all work out what it is :-)