Club G40 Forum

Technical => Superchargers / G-Lader => Topic started by: ereeiz on February 21, 2011, 11:58:56 am

Title: Toothed belt and pulleys kit dimensions
Post by: ereeiz on February 21, 2011, 11:58:56 am

Hello, would anyone be able to give me any specs for a toothed belt kit? I'm interested in the pulleys really as I found out I can get them through work, so am interested in going down this route as an experiment if it works out cheap enough!

Ta.

Title: Re: Toothed belt and pulleys kit dimensions
Post by: scotsjohn on February 21, 2011, 12:07:14 pm

InsightG40's got a set up for sale at this time, give him a bell.

Title: Re: Toothed belt and pulleys kit dimensions
Post by: ereeiz on February 21, 2011, 01:07:13 pm

I was hoping more for technical diagrams on the off chance someone has some I can refer to :P Thanks for the suggestion though.

Also, i found a thread where different grades and different coatings were being applied to the Ali, can't find it now. Anyone got any advice for that?

Title: Re: Toothed belt and pulleys kit dimensions
Post by: Justin14100 on February 21, 2011, 01:50:04 pm

I've been looking into some remakes of the PSD pulleys - I don't have technical diagrams and I can't imagine anyone else having them unfortunately. Normal over the counter pulleys in the sizes are pretty much steel only - to get suitable pulleys for the job they need to be specially made.
As for the aluminium. I have been struggling to find the best one for cheap. Options are a soft Ali with a hard anodised finish, or a harder Ali with a regular anodised finish on them. This is where I'm stuck on it.