Almost finished the rear sections of the floor now, started off making a dozen nylon spacers to ensure the floor is at the desired clearance to the ground:
Untitled by
Peter Strange, on Flickr
After that I could offer up the laser cut plates I'd designed a few weeks back, and see if my measurements were correct (they were):
Untitled by
Peter Strange, on Flickr
With the help of various clamps, pri-pins and the button heads, I started to attach it to the frame:
Untitled by
Peter Strange, on Flickr
Untitled by
Peter Strange, on Flickr
Many rivets later....
Untitled by
Peter Strange, on Flickr
Untitled by
Peter Strange, on Flickr
Happy with the fit:
Untitled by
Peter Strange, on Flickr
So I've got to take the diffuser blades to a local company to be bent, as they're longer than any folder I can borrow, once that's done and they're riveted on, the floor is done (for now). Can then whip it off, primer and treat the underside, refit the fuel tank, make a few modifications to the axle, and then get the car back round the correct way!
All for now
Pete