« previous next »
Pages: [1]   Go Down

Author Topic: Oil pump  (Read 1006 times)

Offline dub-disaster

  • Members
  • *****
  • Posts: 1623
Oil pump
« on: November 09, 2010, 07:22:14 pm »
Took my oil pump apart to measure it up check it out n clean it up. All was lovley but when putting it back together I put a small bead of loctite 574 on it as I thought it would seal it up nicley. This loctite is anerobic and it still spins nicley. But it ocoured to me afterward that it was probly not sealed with sealant or gasket for a reason. Should I take it apart and scrape it all of or just leave it alone now and it will be fine ??
Logged

Offline scotsjohn

  • Members
  • *****
  • Posts: 967
  • Probably the oldest G driver in the Universe.
Re: Oil pump
« Reply #1 on: November 14, 2010, 09:25:42 pm »
The gap between the baseplate and the rotor's pretty critical, I reckon you'd be better cleaning it off.
Logged

Offline dub-disaster

  • Members
  • *****
  • Posts: 1623
Re: Oil pump
« Reply #2 on: November 14, 2010, 09:52:01 pm »
Got paranoid and stuck a brand new one in with no sealant, opened up one that's done 2k miles abd cleaned it all up nicley going to keep it as a spare. thanks anyway though mate
Logged
Pages: [1]   Go Up
« previous next »