Club G40 Forum

Club G40 => General Chat => Topic started by: Oily Fingers on May 26, 2010, 07:10:37 pm

Title: Bar-Tek. Has anyone used them????
Post by: Oily Fingers on May 26, 2010, 07:10:37 pm

Just doing some net searching for my clutch and came across this company in germany.

looks like they got some awsome stuff.

has anyone delt with them before????

http://www.bar-tek-tuning.com/lshop,shopstart,2599,en,1274897241-3552,,,,,.htm

Title: Re: Bar-Tek. Has anyone used them????
Post by: Richg40 on May 26, 2010, 07:12:39 pm

Yes. Never had a problem with them. Along with gladerseite and slstuning.

Title: Re: Bar-Tek. Has anyone used them????
Post by: wierdo on June 01, 2010, 11:01:46 am

I have also used them. There have been mistake with the pulley and the chip. The chip was for 65 mm but the pulley was 68 mm. The car was very rich and I had to fabricate my own pulley to fit the fuel map.
I think also the parts are a bit expensive there.
The good thing is that there are lot of G40 parts.